Martin DMX 5.3 Splitter Instrukcja Użytkownika Pobierz pdf (Strona 8)

8 Stagebar 2 user manual

Physical installation

The Stagebar 2 can be placed on a level, stable surface, installed on the floorstand/mounting bracket

available as an accessory (P/N 71606007) or suspended in any orientation from a truss or supporting

structure using the supplied omega bracket and a rigging clamp. Suitable rigging clamps are available from

Martin.

Warning! Read the “Safety Information” section that starts on page 3 before installing the Stagebar

If the diffuser front is installed, there is no eye hazard at any distance.

Standing installation

If you install fixtures in a standing position:

1. Install fixtures on a level, stable surface where they do not

present a hazard of tripping or falling.

2. Stack a maximum of four fixtures vertically and secure stacked

fixtures so that they cannot fall over.

Flying from a truss, bar or other structure

To fly a fixture from a rig or other structure:

1. Check that the supporting structure can bear at least ten times

the weight of all installed devices, cables, etc.

2. Install a rigging clamp on the supplied omega bracket, then

fasten the omega bracket to the fixture using the quarter-turn

mounting points on the rear panel (see Figure 1 on page 6).

Ensure that quarter-turn fasteners are turned a full 90° clockwise to lock them (see Figure 2).

3. Block access under the work area. Working from a stable platform, suspend the fixture by fastening the

rigging clamp to the truss or structure.

4. As soon as a fixture is fastened in place, install an approved secondary attachment such as a safety

cable passed through the safety attachment eye (see D in Figure 1 on page 6) to secure it.

Figure 2: Locking a quarter-turn

fastener

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Brak uwag

Martin DMX 5.3 Splitter Instrukcja Użytkownika Strona 8