Martin MiniMAC Maestro Instrukcja Użytkownika Pobierz pdf (Strona 40)

Gobos

INSTALLATION

To install gobos

1 Turn off the lamp and allow it to cool for

at least 5 minutes. Disconnect the

fixture from power.

2 Unlock the head cover fasteners by

turning them a quarter-turn

counterclockwise. Open the rear cover

and then lift off the head cover.

3 Turn the gobo wheel as required to

access the desired position. Pull the

gobo holder away from the wheel

slightly to release. Remove the gobo

holder.

4 Remove the gobo retention spring from

the holder and drop out the old gobo.

Insert the new gobo into the holder

true-side-first.

5 Identify the narrow end of the retention

spring by pressing it spring flat: the

narrow end is on the inside.

6 Insert the spring with the narrow end

against the gobo. Push the end of the

spring in under the lip of the holder.

7 Work the rim of the gobo holder under

both clips and snap the gobo holder

back into position. If necessary, a small

screwdriver or similar tool may be used

to pry the clips open.

8 Replace and close the head covers

before applying power.

Flatten spring to find narrow

end. Insert spring with narrow

end against reversed side of

gobo.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 50 51

Brak uwag

Martin MiniMAC Maestro Instrukcja Użytkownika Strona 40