Martin AF-2 Instrukcja Użytkownika

AF-1 and AF-2 fansuser manual

10 AF-1 and AF-2 fans user manualby the clamp manufacturer, through the 13 mm hole in the center of the mounting bracket. • AF-2 fan: Two rigging opti

Installing control hardware 11INSTALLING CONTROL HARDWAREThe AF-1 and AF-2 fans can be operated either using the JEM multifunction remote control unit

12 AF-1 and AF-2 fans user manual AF-1 10 V control installationAF-1 fan speed can be controlled by connecting a suitable analog 0 - 10 volts DC contr

Installing control hardware 13To connect to devices with reversed polarity, use a phase-reversing adaptor (P/N 11820006).To connect the AF-1 to a devi

14 AF-1 and AF-2 fans user manualThe DMX address on AF-1 and AF-2 fans can be set to any channel from 1 to 512 using DIP-switch pins 1 - 10:1. Decide

Installing control hardware 15DMX address DIP-switch settingsTo use this table, first find the DMX address in the main block in the table.Then read th

16 AF-1 and AF-2 fans user manualOPERATIONBefore powering on, check that the fan is correctly and safely installed. Using fans with smoke machinesWhen

Operation 17 Remote control operationThe multifunction remote control unit supplied with the AF-1 and AF-2 fans allows instant or timer-controlled fan

18 AF-1 and AF-2 fans user manualTo set timer operation using the remote control:1. Set the desired amount of airflow using the SPEED control2. Set in

Service and maintenance 19SERVICE AND MAINTENANCEAny service procedure not described here should be referred to a qualified technician. Warning! Disc

680700335320360180AF-1AF-2770750310600390400DIMENSIONSAll dimensions are in millimeters©2005-2007 JEM / Martin Professional A/S. All rights reserved.

20 AF-1 and AF-2 fans user manualAF-2 cleaning access1. Disconnect the fan from power.2. Remove the 16 cross-head screws from the covers (see illustra

Service and maintenance 21grommets (A) are seated in the fan housing (B). If this assembly sequence is not respected, the AF-2 will be excessively noi

22 AF-1 and AF-2 fans user manualTROUBLESHOOTINGProblem Probable cause(s) Suggested remedyNo light from status LEDs on remote control or fanNo powerCh

AF-1 SPECIFICATIONSPhysicalDimensions (L x W x H) . . . . . . . . . . . . . . . . . . . . . . . . . . . 320 x 180 x 360 mm(12.6 x 7.1 x 14.2 in.)Dimen

InstallationOrientation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . anyMinimum clearance aroun

AF-2 SPECIFICATIONSPhysicalDimensions (L x W x H) . . . . . . . . . . . . . . . . . . . . . . . . . . . 600 x 310 x 600 mm(23.7 x 12.2 x 23.7 in.)Dime

ConnectionsRemote control. 3-pin locking XLR, pin 1 shield, pin 2 +15V, pin 3 signal 0-10VDMX . . . . . . . . . . . . 3-pin locking XLR, pin 1 shield,

www.martin.com • Olof Palmes Allé 18 • 8200 Aarhus N • DenmarkTel: +45 8740 0000 • Fax +45 8740 0010

AF-2 specifications 29

CONTENTSIntroduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5Features . . . . . . . . . . .

4 AF-1 and AF-2 fans user manualConnections panelsgfedacb1 2 3 4 5 6 7 8 910ONhi1 2 3 4 5 6 7 8 910ONabcdfegha – Remote inb – Power inletc – Main fuse

Introduction 5INTRODUCTIONimportant! READ AND SAVE THESE INSTRUCTIONS!Thank you for selecting a JEM AF series fan.The AF-1 and AF-2 fans are powerful

6 AF-1 and AF-2 fans user manual• Adjustable flying bracket offering 180° of tilt• Can be flown or placed on a flat surface• Rugged construction.• Sea

Introduction 7• Do not spill fluid over the machine. If fluid is spilled, disconnect the machine from power and clean with a damp cloth. If fluid is s

8 AF-1 and AF-2 fans user manualINSTALLATIONThis product must be installed by qualified personnel only. AC powerAF-1 and AF-2 fans are available in tw

Installation 9Following the cord cap manufacturer’s instructions, connect the yellow and green wire to ground (earth), the blue wire to neutral and th