Martin ATOMIC 3000 Instrukcja Użytkownika Pobierz pdf (Strona 16)

16 Stand-alone operation Atomic 3000 user manual

TAND

ALONE

OPERATION

This section describes how to operate the Atomic 3000 in stand-alone mode

without a DMX controller or Detonator remote control.

STAND-ALONE FLASH RATE

To program stand-alone execution

1 Apply power to the fixture.

2 Set pin 1 of the Mode DIP switch to ON. Set pins 2 - 5 to OFF. Set pin 6 to ON

for low-power operation or to OFF for high-power operation.

3 Select either a flash rate or the blinder effect. You set a flash rate by setting a

value from 1 to 255 with pins 1 - 8 of the Address DIP switch. (See

Table 2.)

The value required to achieve a desired flash rate can be calculated as

follows:

To achieve a flash rate of 10 flashes per second on a 50 Hz AC power supply,

for example, the DIP value is 251. To select the blinder effect instead, set pin 9

to ON.

4 Set DIP switch pin 10 to OFF for normally off operation, or to ON for normally

on operation.

DIP value 261

2 AC frequency×

flash rate

-------------------------------------------–=

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Brak uwag

Martin ATOMIC 3000 Instrukcja Użytkownika Strona 16